Free Republic
Browse · Search
News/Activism
Topics · Post Article

To: American in Israel

From what I understand there are printers which can do metals — and if there aren’t, it’s achievable w/ (a) metal powder and (b) a laser.


13 posted on 02/02/2013 9:10:55 AM PST by OneWingedShark (Q: Why am I here? A: To do Justly, to love mercy, and to walk humbly with my God.)
[ Post Reply | Private Reply | To 3 | View Replies ]


To: OneWingedShark; All
From what I understand there are printers which can do metals — and if there aren’t, it’s achievable w/ (a) metal powder and (b) a laser.

This really requires another thread..

I am not enamored with this printing, did SLA files when it was cutting edge, and I know enough about Metallurgy, heat treating, plating, Normalizing etc to make me dangerous, I don't see it.....

But the for-mentioned thread for these below, and check out the other videos while on the page.

https://www.youtube.com/watch?v=Ao319dj6kiM

https://www.youtube.com/watch?v=A10XEZvkgbY

33 posted on 02/02/2013 10:54:14 AM PST by taildragger (( Tighten the 5 point harness and brace for Impact Freepers, ya know it's coming..... ))
[ Post Reply | Private Reply | To 13 | View Replies ]

Free Republic
Browse · Search
News/Activism
Topics · Post Article


FreeRepublic, LLC, PO BOX 9771, FRESNO, CA 93794
FreeRepublic.com is powered by software copyright 2000-2008 John Robinson