Posted on 04/03/2016 3:56:20 PM PDT by Incorrigible
I tend to agree...Multiple screw ups...
I know nothing about inspection procedures for nuclear submarines, but was a certified welder and did a fair amount of pipefitting using both arc and TIG welding of steel and stainless pipe...
Piping engineered to carry high psi and or corrosive loads is usually inspected multiple times visually, using x-ray, ultrasonic, mag particle, and even occasionally subjected to destructive testing...Lots of people need to sign off, welder, inspectors and their respective supervisors all included...
It’s conceivable one defect may have slipped past multiple quality control inspectors using a combination of inspection techniques, but there appears to be a pattern, which suggests incompetence and/or malfeasance...
Precise technical term for power plant failure near test/design depth would be BAD! The USS Thresher comes to mind...
The reason I axe this is because Nuflo, the maker of the defective pipe, partnered with a German company called KME, wihc doesn't run afoul of the Jones Act, apparently.
Whoever signed off on the inspection of the work done should be prosecuted as well.
Was there even any inspection done? Or was the guy in a hurry to start his weekend or something??
Why do I have a feeling these parts were made in China?
So much for the “Sub-Safe Program”...
No excuses, though, when it comes to the described weld failures in this story.
It was defective and/or failed joints that led to the loss of the USS Thresher in April 1963. That disaster is what spawned the birth of what was known as ‘SUBSAFE’, an internal Navy program to guarantee that such a loss could not happen again.
The Thresher (SSN-593) and the Scorpion (SSN-589) are the only nuke subs we’ve ever lost at sea, hopefully there will never be any more.
“Oh my. I would have expected this to have been tested eight ways from Sunday before it was ever fired up with radioactive fuel.”
It is, or should have been. This is the kind of mistake that can only happen if somebody was on the take. But hey, Hillary shows that everybody needs to get theirs.
K 19 the widow maker
Great film!!! Harrison Ford.
That is Affirmative Action for you.
Affirmative Action, My FRiend, Affirmative Action.
I don’t believe an experienced inspector was NOT assigned to inspect the welds before nuclear fueling of the vessel. I don’t believe it.
Somebody had to know, and somebody dodged their responsibility for some reason that must be found out.
I bet that you are correct.
They were made here in Jacksonville, Florida, a proud Navy town.
I seem to recall that Thresher was ultimately doomed by ice on the air manifold in the ballast tank which prevented an emergency blow.
The problem that caused the cascade effect was a leaky welded joint and powerplant shut down.
The outcome was SUBSAFE.
I would opine that Affirmative Action was the weldor’s certifications.
I traveled a lot around Russia and a great deal of Georgia.
Worst thing was finding the courage to cross streets in Tbilisi.
Planes in Rostov on don were shakier than you can imagine in the late 90’s.
barking up the wrong tree.
a good ol’ american worker is almost certainly at fault.
it is likely not a part but a welder at fault and defective or faked x rays
You have seen The Widow maker too? I love that movie.
Thermal sleeve?
Disclaimer: Opinions posted on Free Republic are those of the individual posters and do not necessarily represent the opinion of Free Republic or its management. All materials posted herein are protected by copyright law and the exemption for fair use of copyrighted works.