Replies

Speaking of KB's... here's something that might help somebody else...As with all things worth knowing, there's a bit of a story, so please bear with me. :-)

My brother and I were shooting .45ACP one weekend at his house. We were practicing what we call "two shot drills". The basic intention is to retrieve the weapon from where it's holstered and get two rounds on target quickly. The shooter walks AWAY from the target until the other guy gives the order to turn and shoot.

Anyway... malfunctions are handled accordingly... drop the mag, rack the slide twice, reinsert the mag....rack the slide.

It was my turn and I fired once...twice...and the second one "felt" strange. I didn't realize that the pistol didn't cycle and that there was a bullet lodged in the barrel.

So I went through a clearing drill and noticed the slide didn't "go home" solidly on a new round in the chamber. So I STOPPED and started looking for the source of the problem.

We quickly discovered the bullet in the bore. It wasn't quite far enough in to permit the next round to chamber completely. We drove it out and set that batch of reloaded ammo off to the side. It was loaded on a Dillon RL-550B and I called Dillon the following Monday. After explaining all the details and answering numerous questions, the guy at Dillon told me that it was because we were using old Bullseye. He said that if we dumped it onto a dinner plate, we would probably see small clumps that could (and DID) interfere with the flow system on the reloader. He said if we used a small tined fork or something else to break up the clumps, it would feed!

So my warning here is with respect to older Bullseye, if anybody has any stored. There was no harm done in my case, but if I had "shooting badguys", and under stress I know for a fact that I would have probably NOT been inclined to stop so fast and examine the source of the stoppage and then damaged the weapon by firing a good round behind the projectile lodged in the barrel.

Needless to say... me and my helper weighed "about" 800 rounds out of that run of reloads and everything weighed within spec...so apparently there was only ONE squib load. Also...due to the way that the powder flow system on the Dillon is made, it won't drop a double charge into the one following the squib. Older models of the Lee 1000 did this back in the early 1990s....so not only would you end up with a squib, but the one right after it would receive a double charge! As I understand it, Lee fixed this soon after it was discovered.

For the most part, we're running out of of Bullseye and are using WST (Winchester Super Target) for .38SPCL, .40S&W and .45ACP. It "seems" to do a good job. :-)