Free Republic
Browse · Search
General/Chat
Topics · Post Article

Skip to comments.

Moisture Sealing An Unfinished Concrete Floor - Advice Please!

Posted on 02/27/2014 5:11:03 AM PST by newb2012

Looking to moisture seal my unfinished basement’s concrete floor as a measure to cure and prevent mold in the house. Appreciate any suggestions, sources and references - about what kind of sealant to use etc.


TOPICS: Health/Medicine; Miscellaneous
KEYWORDS:
Navigation: use the links below to view more comments.
first previous 1-2021-4041-6061-64 next last
To: ansel12

They’re exactly the same way at Best Buy. Someone can go in there needing a device to achieve some sort of solution or goal, and one of their idiot employees will have them leaving with a $700 cart full of ‘stuff’, while a simple $15 part would have sufficed(I’ve seen that happen MANY times to people I do IT work for).

I suppose that’s a GREAT business model, assuming everyone is ignorant.(more so than the store employees)


41 posted on 02/27/2014 1:32:24 PM PST by KoRn (Department of Homeland Security, Certified - "Right Wing Extremist")
[ Post Reply | Private Reply | To 40 | View Replies]

To: KoRn

What hurts, is when Home Depot employees confidently give advice which is destructive and wrong, on matters that will cost a fortune to repair within just a few years.

As a contractor, I see Home Depot as a business that has had a devastating effect on American home repairs and remodeling over the last 30 years, they trashed the American home.


42 posted on 02/27/2014 1:54:39 PM PST by ansel12 (Ben Bradlee -- JFK told me that "he was all for people's solving their problems by abortion".)
[ Post Reply | Private Reply | To 41 | View Replies]

To: ansel12

Note how in my original remarks, I referred to one of their job requirements as having to “give authoritative bullshit answers”. They must SOUND like they know what they’re talking about. Which leads to the scenario you just explained.


43 posted on 02/27/2014 2:23:25 PM PST by KoRn (Department of Homeland Security, Certified - "Right Wing Extremist")
[ Post Reply | Private Reply | To 42 | View Replies]

To: ansel12

>> “As a contractor, I see Home Depot as a business that has had a devastating effect on American home repairs and remodeling over the last 30 years, they trashed the American home.” <<

.
And they have run off the legitimate operators in most locales.

In the Bay Area, it was Yard Birds that was the good operation, but Home Depot bought them out and shut them down.
.


44 posted on 02/27/2014 2:39:27 PM PST by editor-surveyor (Freepers: Not as smart as I'd hoped they'd be)
[ Post Reply | Private Reply | To 42 | View Replies]

To: tomkat; thackney

Back with more questions. I did get the dehumidifier that you recommended. Moisture level in my basement currently is below 30%. The contractor who came into do some other work feels (looking at the moisture levels and also since there is no visible presence of mold ) epoxy paint might be an overkill especially since I’ll be finishing the basement in a year or two. He thinks a couple of coats of concrete paint would work equally good. Appreciate any thoughts or suggestions.


45 posted on 03/17/2014 7:58:40 PM PDT by newb2012 (Fear distorts your vision. Often reality is much easier to deal with.)
[ Post Reply | Private Reply | To 37 | View Replies]

To: newb2012
The Epoxy-Seal product I detailed at some length above is a durable, affordable middle option between plain floor paint and full blown epoxy when applied properly, impo.

You're going to find that any reputable coating intended for concrete will BLARE AT YOU on the directions the need for etching prior to painting bare concrete.
Granted it's a time-consuming chore, but it's ignored at peril of wasting coating money and applicator's time.
(not to mention voiding any possible warranty claim)

Glad to hear the dehumidifier is working out for ya .. good luck with the floor.

46 posted on 03/17/2014 9:30:35 PM PDT by tomkat
[ Post Reply | Private Reply | To 45 | View Replies]

To: newb2012

It is dry now because it is exposed to air that is being dried by the humidifier.

When you finish off the basement, I expect you will have some type of barrier, paneling, wallboard, etc that will prevent your dehumidifier from adequately keeping that surface dry.

You have not stopped the moisture intrusions. The dehumidifier is just drying it up as fast as it comes in. As long as the surfaces are exposed, this works fine.

If you are going to cover up that porous block and concrete, preventing the direct drying action on the surface, you should expect mold behind the walls you put up.

Unless that “concrete paint” is a complete moisture barrier, I would not use it.


47 posted on 03/18/2014 4:39:59 AM PDT by thackney (life is fragile, handle with prayer)
[ Post Reply | Private Reply | To 45 | View Replies]

To: thackney; tomkat

Thank you for your quick reply. Is it necessary to use a moisture barrier on the walls too? I feel it is because most part of the wall is underground too.


48 posted on 03/18/2014 6:44:46 AM PDT by newb2012 (Fear distorts your vision. Often reality is much easier to deal with.)
[ Post Reply | Private Reply | To 47 | View Replies]

To: newb2012

I would think so as well.

The lowest points will have the highest moisture level.

I don’t know your soil and conditions. But you had a problem prior. I would want to be sure the problems was sufficiently protected before I spent money putting other finishing on top of it that would be damaged by mold growth.

My 2¢


49 posted on 03/18/2014 7:32:36 AM PDT by thackney (life is fragile, handle with prayer)
[ Post Reply | Private Reply | To 48 | View Replies]

To: newb2012; thackney
Your main enemy below grade is a critter called efflorescence .. you'd be well-served spending an hour reading up on it.

All I can do is relate the experience I've had treating the basement in my home and several others.
This place has 140LF of exterior walls and 100LF of interior walls (both sides), so using it as an example:

After proper prep work, I applied 2 coats of DryLok to the exterior walls, taking care to get as many of the pinholes as possible.
After that thoroughly dried, I went over them again with an exterior latex semi-gloss, and did two coats of the same semi-gloss on the interior walls.

I'd agree with thackney re the problems inherent in covering concrete block below grade with other wall materials eg drywall/paneling/etc.
Tho prop prep and DryLok or similar will keep it to a minimum, there'll always be some moisture, hence your shiny new dehumdifier.

I'm not affiliated in any way with either or SealKrete or DryLok other than having used them with good results professionally.
You should still read up on effloresence, but additionally DryLok has a good web page here with a step by step overview of the hows and whys of the process.

I've had zero leaks in ten years, and only this past autumn gave them all a single coat of the semi-gloss latex only.
Tho that was only because I'm out in the country next to a big corn/dairy operation and microdust is a fact of life, weekly vacuuming notwithstanding.
But that's a rant for another day .. lol !

50 posted on 03/18/2014 8:05:16 AM PDT by tomkat
[ Post Reply | Private Reply | To 48 | View Replies]

To: tomkat
I applied 2 coats of DryLok to the exterior walls,

You coated the exterior surface? Or the interior surface of the block wall that is below grade?

51 posted on 03/18/2014 8:10:13 AM PDT by thackney (life is fragile, handle with prayer)
[ Post Reply | Private Reply | To 50 | View Replies]

To: thackney
The latter .. shoulda been a bit more clear, ehh ? .. hopefully he has some kinda parging on the exterior of the exteriors !

(think that's confusing enough ?  d:^)

52 posted on 03/18/2014 8:18:16 AM PDT by tomkat
[ Post Reply | Private Reply | To 51 | View Replies]

To: ps

.. if not, he’s gonna need a bigger dehumidifier !


53 posted on 03/18/2014 8:19:11 AM PDT by tomkat
[ Post Reply | Private Reply | To 52 | View Replies]

To: pps
.. and some mops


(ok, i'm leaving now .. lol)

54 posted on 03/18/2014 8:21:23 AM PDT by tomkat
[ Post Reply | Private Reply | To 53 | View Replies]

To: newb2012

Drylock for moisture, I also like California All Flor for concrete floors


55 posted on 03/18/2014 9:00:29 AM PDT by vigilante2 (Re-elect nobody)
[ Post Reply | Private Reply | To 1 | View Replies]

To: vigilante2
No Home Depot!!!!!
56 posted on 03/18/2014 9:02:26 AM PDT by vigilante2 (Re-elect nobody)
[ Post Reply | Private Reply | To 55 | View Replies]

To: vigilante2

Thank you. I used dry lok. I went with seal krete for floor. So far looks pretty neat.


57 posted on 03/26/2014 9:23:11 PM PDT by newb2012 (Fear distorts your vision. Often reality is much easier to deal with.)
[ Post Reply | Private Reply | To 55 | View Replies]

To: thackney; tomkat

Thank you! I followed every step that you suggested( Yes! I did read your Disclaimer :)) and so far things look great. Just applied the first Sealkrete coat and waiting for it to dry to do the rest.
Gotta admit that I don’t have any knowledge of these products, processes etc. But felt pretty confident after getting your advice. Talked like a pro with the contractors ;) Thanks a lot.
Will keep you posted. Might come back for advice on some more projects that I have in line.


58 posted on 03/26/2014 9:23:11 PM PDT by newb2012 (Fear distorts your vision. Often reality is much easier to deal with.)
[ Post Reply | Private Reply | To 49 | View Replies]

To: newb2012

I’m glad it worked out for you. I didn’t get to ask if you were actually getting ground water in the basement. Those products work well but won’t stop a leaking floor or foundation..


59 posted on 03/26/2014 9:32:19 PM PDT by vigilante2 (Re-elect nobody)
[ Post Reply | Private Reply | To 57 | View Replies]

To: newb2012
That's good news .. appreciate the update, as these kinda threads usually attract numerous interested lurkers .. lol

Am curious to know if you hired someone or ended up tackling the job yourself ?

Either way, don't get in too big a hurry with your subsequent coats .. 24hrs is a good/safe rule of thumb.

One last thing > if you/family members plan on being on it in sock feet, have a gingerly trial run first to get the 'feel' of it.
The ClearSeal can make it seem a little slippery at first depending on the texture of your floor and/or how smoothly it was trowelled .. barefoot or w/shoes, no problem at all.

Hope it works out for ya.
Imho, way too many basements end up being nothing but box storage when, with not much investment of time/$, they can add lots of nice living space to a home.

60 posted on 03/27/2014 5:28:10 AM PDT by tomkat
[ Post Reply | Private Reply | To 58 | View Replies]


Navigation: use the links below to view more comments.
first previous 1-2021-4041-6061-64 next last

Disclaimer: Opinions posted on Free Republic are those of the individual posters and do not necessarily represent the opinion of Free Republic or its management. All materials posted herein are protected by copyright law and the exemption for fair use of copyrighted works.

Free Republic
Browse · Search
General/Chat
Topics · Post Article

FreeRepublic, LLC, PO BOX 9771, FRESNO, CA 93794
FreeRepublic.com is powered by software copyright 2000-2008 John Robinson