Posted on 10/28/2023 4:36:38 AM PDT by marktwain
It depends on what is offered, but on the order of 1-5.
A suitable starter 3D printer can be had for about $250.
The big cost is not the printer or the filament. It is the learning curve to use the printer.
Well. . .you can buy an Ender3 for around $200, and a kilogram spool of PLA for 20-25 bucks each.
A minima! 3d printed pistol takes about 500 grams of plastic.
So it would depend on the buyback offer, but likely anything over 50 bucks would be pure profit for over 6 or so pistols...
Wish I was close by so I could see what I can buy for 325 or 350. Or sell some junk.
NM 2023 Gun Buy back info.
Wish I was close by so I could see what I can buy for 325 or 350. Or sell some junk.
NM 2023 Gun Buy back info.
Disclaimer: Opinions posted on Free Republic are those of the individual posters and do not necessarily represent the opinion of Free Republic or its management. All materials posted herein are protected by copyright law and the exemption for fair use of copyrighted works.