[atomic_dog]

Actually there is another solution, the cnc mill.

[Utilizer]

Hmmm. My first thought upon reading your post was that you must have cross-posted, as yours was rather specific and not completely within what the thread was started about.

Then I thought, right, then, it shows one way to get past some of the governmental rigamarole, so plus points for that.

Then the next thought was... ehrmmm, mate: I don't have access to a CNC mill, and know of few others that do. Quite few, actually. Perhaps a link to a source where dirt-cheap machining tools such as lathes mills and benders or at the very least drill presses and Dremel bits would be a quiet and subtle way to point out some options...

[RC one]

pretty. I wonder what it looks like on the inside? Wide or narrow?