THE TOP TEN MOST SURPRISING 'MORMON TEACHINGS' ABOUT MORMON HEAVEN and AFTER-LIFE [Vanity]

Colofornian | July 4, 2012 | Colofornian

[MHGinTN]

There is another technique I’ve used to form parts for guns. It involves somehting similar to bedding and psot work on a rifle stock, where the metal is coated with a releasing agent then the metal is pressed into a wet bed of epoxy untilt he epoxy dries, then remove the metal part and clean the releasing agent off. Makes a nice tight fit, but the wrapped outside of the plastic cylonder into which the metal post fits works well enough on these twist-dial handles.

[Utah Binger]

Thanks!

I’ll try to figure this out. Need to drive down to Kanab to get the J-B Weld.

[Elsie]

So if I form a new slot quickly with JB Weld into the damaged dial shown here using the peg shown below it will hold?

Try it to see!

I just mixed up the JB stuff I purchased earlier today.

The setup time is a BIT faster in 102° heat!

When I'm done educating mis-informed MORMONs in a few; I'll head back out to the barn and see how my handiwork has progressed.

[Elsie]

The last time I went thru Kanab, my pooch and I were headed to Lee's Ferry in Ol' Blue: my '77 Chevy 1 ton van that's been pert near ever whir!

It was 107° as I headed into the parking area and my dog found the irrigation ditch to the peach trees really quickly!

[pigsmith]

bfl