1 posted on
07/23/2013 11:17:17 PM PDT by
neverdem
To: neverdem
gotta go to bed... i was thinking of going to the beach in a pair of printed flip flops
2 posted on
07/23/2013 11:26:17 PM PDT by
HiTech RedNeck
(Whatever promise that God has made, in Jesus it is yes. See my page.)
To: Coleus; Peach; airborne; Asphalt; Dr. Scarpetta; I'm ALL Right!; StAnDeliver; ovrtaxt; ...
3 posted on
07/23/2013 11:35:17 PM PDT by
neverdem
(Register pressure cookers! /s)
To: neverdem
Gives new meaning to the words ‘plastic surgeon’.
Wonder if they can print breasts and male organs ?
When will we be able to print a person ?
4 posted on
07/23/2013 11:50:33 PM PDT by
UCANSEE2
(The monsters are due on Maple Street)
To: neverdem
"Bannock says that for chemists, an off-the-shelf 3D printer has limited use. Most of the materials are not tolerant to any organics, he says, adding that there is a need to move to polytetrafluoroethylene derivatives. Ive contacted the major companies that make the printers but none seem to have tried this, despite the starting materials being widely available, says Bannock. He says that the investment companies would need to make is putting them off. Actually, the printers to handle this are already available in the "open source" world. They are the "photopolymerization" type that print layers on exposure to a flash of light. These printers use the internals of a DLP projector.
There is also a photopolymerizable monomer that has the needed properties to yield a Teflon-like material. The problem is that said monomer is not commercially/inexpensively available. "Somewhere" on my desk I have a paper detailing the synthesis of the monomer. If I can locate it, I'll post the reference.
FreeRepublic.com is powered by software copyright 2000-2008 John Robinson